China trampoline with net,Trampolines Factory

Shaoxing Qianjiang Yarun Household Products Co.,Ltd

The installation steps of the bungee trampoline

Update:24 Aug 2019
Summary:

The trampoline manufacturer tells you the installation […]

The trampoline manufacturer tells you the installation steps of the bungee trampoline

step one

1. Select a centered column and place it on a flat floor. Place the center column straight and do not tilt it. The lower slanting rod and the central column are fixed obliquely and fastened to each other. Then connect the lower slanting rod fastening joint to the center fastening chain, not too tight.

2. First, fasten the fastening wire rope to the chicken heart ring separated by the upper diagonal bar.

3. The vertical alignment of the vertical slanting rod soft bungee jumping bed is installed on the center column, and then the upper slanting rod and the vertical rod are connected to each other.

4. Separate the hooks on the two lifting wire ropes from the left and right sides of the upper diagonal bar. Connect the wire rope head to the outside to secure the hook, elastic rope and seat belt.

5. Separate the two people from each other. Pull up the lifting wire rope and form a straight line. Hold the vertical and vertical slanting rods and straight up and slowly rise until the upper slanting rod and the center column are fixed together.

Step two

1. Pull up the two fastening wire ropes that are connected to the upper oblique end and hang them on the steel rings at the middle end of the adjacent left and right lower slanting rods, and tighten them tightly.

2. The center of the upper slanting rod is spliced ​​to the fastening ring at the middle end of the adjacent upper slanting rod. The slanting rod is adjusted by the basket screw to be flat and tight, and the vertical rod is straight.

3. The electric hoist is mounted on the motor mount of the center column. The wire rope limit switch of the electric hoist is held in the center of the center column.

4. The electric hoist wire rope head has a central hole and a hook which are chained up and down through the limit block. After being removed, the wire rope is fastened and fastened.

5. The heart ring in the lifting wire rope is connected with the electric hoist hook. The limit stopper core needs to be adjusted until the top end of the lifting wire rope is 5-10cm away from the pulley, and the limit switch is actively disconnected.